Working Instructions - Fein Slugger JHM USA 101 X Manual

Working instructions.

When there is danger of falling down, secure the machine using the provided
WARNING
safety strap; especially when working aloft, on vertical building elements or
overhead. In case of a power failure or when the mains plug is pulled, the magnetic holding
power is not maintained.
Fastening the safety strap (figure 7).
Always fasten the machine securely around
the workpiece using the provided safety
strap.
For switching the magnet ON
(figure 8).
Please make sure that the contact sur-
facefor the magnetic base is level, clean
and rust-free. Remove any varnish or
primer.
When working, always use the magnetic
base; ensure that the magnetic holding
power is sufficient.
When working on materials that are non-
ferrous, suitable fixation devices obtainable
as accessories from the manufacturer, e. g.
suction plates, vacuum plates or pipe-drilling
devices must be used.
When working on steel materials with a
material thickness of less than 12 mm /
1
/ in, the workpiece must be reinforced
2
with an additional steel plate in order to
guarantee the magnetic holding power.
Press the magnet switch to energize the
magnet.
Magnet switch
en
13
Safe t y s t rap