Working Instructions - Fein ASCD18W2 Instruction Manual

OBJ_BUCH-0000000122-001.book Page 14 Friday, April 19, 2013 10:39 AM
en
14

Working instructions.

Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by FEIN.
The use of non-original FEIN accessories can lead to overheating of the power tool and destroy
it.
For each job, use only the FEIN application tool released and intended for the
CAUTION
respective application.
Apply the power tool to the nut or screw
only when switched off, as a rotating applica-
tion tool could slip off.
The torque depends on the impact duration.
The maximum torque is reached after an
impact duration of 6–10 seconds. After this
period, further torque increase is only mar-
ginal. An unnecessary long impact period also
increases the wear of the power tool.
Selecting the rotation direction
(figure 5).
To avoid accidental starting, e. g., during
transport, set the rotation selector switch to
the centre position.
Set the Rotation selector switch to right or
left rotation as required.
Adjust the rotation selector switch only
when the machine is at a complete stop.
Determine the impact duration for each
required tightening torque. Check the actually
reached tightening torque with a torque
wrench.
Fig. 5
Rotational direction switch