SunStar KM-1070 SERIES User Manual page 16

4.5.10) Belt Cover Installation
1) Fix the belt cover on the upper right side of the
arm and the fixing grooves of the belt cover
using screws
2) Accurately assemble the belt covers ,
the belt cover
method. When the assembled belt cover is fixed
to the stud bolt
installation is complete.
4.5.11) Pneumatic Parts Installation and
Function Check
1) As in the figure, fix the pneumatic unit
lower part of the table using the wood screw and fix
the regulator to the table T-leg stiffened plate
2) Connect the pneumatic tubes according to label
signs and bind the tubes with other lead lines
using the belt clips
3) Use the regulator
pressure at 0.5Mpa.
4) When applying the seam center guide presser
foot, make sure that the pneumatic pressure of the
regualtor
4.5.12) Description of label symbols
Label Sign
S1
S2
S3
S4
S5
S6
S7
S8
However, when the left/right removable thread adjustment device, an optional device is applied, S6
refers to SubL, and S9 refers to SubR.
Note
16
.
using screws following the same
using screws , the belt cover
.
to set the default pneumatic
is no highr than 0.3Mpa.
Cylinder
Backtack
Trimming
Hem height difference
Stitch length conversion
Thread release(Main)
Thread release(Sub)
Presser foot
Seam guide
and fix
to the
.
Add the initial and last backtack sewing function and perform reverse sewing
Perform trimming
When the cylinder is in motion, sewing is performed using the higher
value of the two climb dials attached to the machine.
When the cylinder is in motion, sewing is performed using the lower
value of the two stitch length dials attached to the machine.
It operates when trimming and presser foot automatic lift are
performed to loosen the tension of the upper thread.
Turn on/off the tension of the upper thread using the function switch.
Lift the presser foot 18mm from the needle plate face.
It is used to create sewing lines in parallel along the seam in case of
using two needles.
Function
[Fig. 4-14]
[Fig. 4-15]