Moving Players From One Spectrum Server To Another; Removing A Mediadeck From Systemmanager - Harmonic Spectrum MediaDeck 7000 Component Replacement Manual

What to do next
NOTE: If replacing a MediaDirector: It is recommended that every MediaDirector sharing
a File System (EFS) be rebooted after one MediaDirector has been replaced. This ensures
that they are all in sync.

Moving players from one Spectrum server to another

This feature is useful when a MediaPort is "moved" between Spectrum servers, and when Spectrum
servers need to be serviced. Players may be moved from Spectrum servers that are not responding.
NOTE: In this context, "moved" means physically removing a MediaPort or Spectrum X
from the source Spectrum server's 1394 bus by disconnecting its IEEE 1394 cable, and
then reconnecting its IEEE 1394 cable to the destination Spectrum server.
1. From the Configuration tab in SystemManager, click the Player Configuration icon on the left-hand
column.
If you have replaced a Spectrum server, the page should show 0 players configured for that server.
2. Select the destination Spectrum server.
The Player List page appears.
3. On the Player List page, under Move Players from another media server, use the dropdown box to
select the host of the original Spectrum server, which has the players you wish to move.
4. Click Select Players.
The Select Players page appears, showing a list of those players that reside on the Spectrum server
you chose.
5. Select the players that you wish to move by clicking the appropriate check boxes. Optionally, click
Select all Players.
6. Click Move to perform the move function between Spectrum servers.
The selected players will disappear from the list.
7. Click Done to complete the move.
8. Harmonic recommends you verify that the players are usable by recording or playing material using
those players on their new Spectrum server.

Removing a MediaDeck from SystemManager

Remove a device that is no longer part of your Spectrum system.
1. From the Diagnostics tab, click the Remove Device icon in the left-hand column.
The Remove Device page appears.
2. If the device you are remoivng is not responsive, find the device in the Not Responding Devices
section, select it, and then click Remove Not Responding Devices.
The device is removed (it has also been removed from the System Diagram), and this completes the
procedure.
3. If you are removing a device that is responsive, follow these steps:
a. Click Stop Monitoring.
Once the "Current state of Device Monitoring" changes to Not monitoring, continue to the next
step.
MediaDeck 7000 chassis replacement
29 MediaDeck Component Replacement Guide