Deleting An I/O Module From Systemmanager; Installing The Replacement Module - Harmonic Spectrum MediaDeck 7000 Component Replacement Manual

Spectrum
3. Using both hands to grip the screws, gently pull out the module from the chassis, as shown in the
following figure.

Deleting an I/O module from SystemManager

Once you have removed the module from the chassis, delete the corresponding I/O module from
SystemManager.
1. Click the Diagnostics tab to display the Diagnostics page.
2. From the Device Maintenance section in the left-hand column, click the Remove Device icon to
display the Remove Device page.
3. Scroll to the I/O Modules section of the page and locate the module you wish to remove.
4. From the Select column, check the box for the I/O module you wish to remove, and then click
Remove.
A confirmation message appears.
5. Click OK.
After a brief pause, a message appears indicating that the device has been removed (it has also been
removed from the System Diagram).
6. Click OK to return to the Remove Device page.

Installing the replacement module

Secure the module to the chassis using a cross-head screwdriver.
1. Unpack the module.
2. Grasp the module handle and push firmly into the slot. Ensure the module is fully inserted by pressing
on the connectors with the palm of your hand.
3. Tighten the two lock screws on the rear panel of the module to secure it to the chassis.
4. From the Configuration tab of SystemManager, view the System Diagram page and verify that the
new module appears.
2
20
3