Configuring The Device - Siemens RUGGEDCOM RX5000 Installation Manual

Chapter 2
Installing the Device
Figure 10: Serial DB9 Console Port
The management port is a 10/100Base-TX copper Ethernet port with an RJ45 connector. The following is the pin-
out for the management port:
8
Figure 11: RJ45 Management Port
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch and access the RUGGEDCOM
ROX II console and Web interfaces via the device's IP address. The factory default IP address for the RUGGEDCOM
RX5000 is https://192.168.0.2.
For more information about available ports, refer to
Section 2.10

Configuring the Device

Once the device is installed and connected to the network, it must be configured. All configuration management
is done via the RUGGEDCOM ROX II interface. For more information about configuring the device, refer to the
RUGGEDCOM ROX II User Guide associated with the installed software release.
16
5 1 1
9 6
1
Pin
1
2
3
4
5
6
7
8
9
Pin
1
2
3
4
5
6
7
8
Modules.
Chapter 3,
Installation Guide
Name Description
DCD Data Carrier Detect
RX Receive Data
TX Transmit Data
DTR Data Terminal Ready
GND Signal Ground
DSR Data Set Ready
RTS Request to Send
CTS Clear To Send
Reserved (Do Not Connect)
Name Description
TX+ Transmit Data+
TX- Transmit Data-
RX+ Receive Data+
Reserved (Do Not Connect)
Reserved (Do Not Connect)
RX- Receive Data-
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Configuring the Device
RUGGEDCOM RX5000