Table of Contents
Advertisement
Figure 346 – Loopback Test
To start the loopback test, do the following:
Endpoint IP – specify the device's IP address, whose transfer rate needs to be measured.
Start – click to start measuring the specified wireless link.
The status line will show the last measured data transfer rate and the time when this data was
received from the wireless network device.
To stop loopback test simply click the Stop button.
SNMP Settings
SNMP (Simple Network Management Protocol) can be configured using the SNMP Settings. Several
Read-Only and Read-Write communities can be specified here. The Community strings are used for
SNMP authentication purposes. It is possible to allow or deny IP address groups from accessing the
P-360 using SNMP. To add new Read-Only or Read-Write community, click the Add New Rule next
to appropriate table.
Gemtek Systems
Page 40
Advertisement
Table of Contents
