Removing The Access Point From The Wall; Software Installation; Find Your New P-360 - Gemtek Systems P-360 User Manual

Removing the Access Point from the Wall

1. Open the housing of the Access Point by pressing the spring latches on the upper rear side of the
access point using the disassembling tool delivered with your P-360.
Figure 3 -- Removing the P-360 housing using the disassembling tool
2. Release the housing from the wall mounting clamp by carefully pressing the spring latch in the
center of the device (see Figure 3 -- Removing the P-360 housing using the disassembling tool)
using the small edge of the disassembling tool.
3. Move the housing slightly downward and remove it.

Software Installation

Insert the installation CD delivered with your new P-360 Access Point into your CD-ROM drive.
The installation wizard starts automatically and will guide you through the rest of the installation
process. If the installation wizard does not start automatically, please run "autorun.exe" manually
from the root directory of the installation CD.
Software is needed for setup and management of the P-360 HiaB Access Point.
In general, there are four different ways to access the device:
•
Windows applications: AP search and AP upgrade (installation required)
•
Standard HTML browser (Java and JavaScript enabled) using Configuration Manager
•
CLI (command line interface)
•
SNMP

Find Your New P-360!

To find your new P-360 HiaB Access Point you will need to connect the AP to the same logical
network as your PC. The standard IP address of the P-360 in factory default status is 192.168.2.2. To
access the P-360 in its default configuration you will need to use one of the following IP settings in
your network:
•
IP address space 192.168.x.x
•
Subnet mask 255.255.0.0
Gemtek Systems Page 14