Table of Contents
Advertisement
System Tools
Using this menu you can perform system tests, configure SNMP settings, upgrade firmware, restart or
reset HiaB Access Point into factory defaults.
Clients
All clients currently connected to the P-360 Access Point is listed in the Connected Clients table. The
clients are listed by its MAC address.
Figure 335 – Connected Clients
Click the Refresh button if you want to renew the connected clients statistic.
Loopback Test
The loopback test is used for wireless link diagnostics. The loopback test graphically shows the data
transfer rate in Mb/s between the P-360 and a specified wireless network device. The transfer rate is
measured by sending an ICMP stream to the specific device. Data is refreshed every 10 seconds.
Gemtek Systems
Page 39
Advertisement
Table of Contents
