Table of Contents
Advertisement
Advanced Settings
Setting up the P-360 advanced settings requires advanced knowledge of the
TCP/IP network structure and functionalities. It is recommended that only skilled
network administrators should use these settings.
ACL Settings
In the ACL Settings page you can specify default access policy for wireless or Ethernet network
devices.
Default ACL policy for wireless network: Select Accept to allow all mobile clients to access this
access point or Deny to prevent all mobile clients from access to your access point. Clients may also
be subject to rules in the Access control table.
Default ACL policy for Ethernet: Select Accept to allow all LAN clients to access this access point
or Deny to prevent all LAN clients from accessing your access point. Clients may also be subject to
rules in the Access control table.
Figure 17 – ACL Settings
If you need to define special access rules for specific network devices, you can create your own
access list. Access control list is based on the networks devices' MAC address. Just specify network
device MAC address and it's access policy (accept/deny) with new rule in the Access control table.
Click the Add New Rule button and define new specific rule in the following page:
Gemtek Systems
Page 26
Advertisement
Table of Contents
