Table of Contents
Advertisement
Section 4: Vehicle Operation
Trouble shooting
After installation the touch pad does not work
●
Batteries are dead/need to be replaced or are not installed properly
●
Plug not engaged properly
Dead Bolt not engaging into Door Frame
●
Obstruction in Door Frame
Code not working
●
Remove Batteries for 10 seconds then Program New Code
Inside Paddle not Opening Latch
●
Inside screws are not secured to the Housing
Buttons light but the Dead Bolt does not activate
●
Replace the batteries
If the problem is not found on this list, refer to the manufacturer's operator's manual.
Battery Installation:
The entry system uses 4 AA alkaline batteries for operation. Do not use Zinc carbon
batteries. Fresh batteries should be installed as necessary. Do not mix old and new batteries.
Remove batteries if the lock will not be used for extended periods of time.
The following steps are shown on the enclosed Battery Installation schematic.
1.
Remove (2) 4x40 screws from Battery Compartment Lid. These screws are very small
so please take care in removal and installation.
2.
Install the AA batteries in accordance with the orientation symbols shown in the Battery
Compartment. The batteries will fit tightly.
3.
Install Battery Compartment Lid by aligning the (3) tabs on the lid with the (3)
slots on the Inside Plate Assembly. These tabs act as a hinge for closing the Battery
Compartment Lid.
4.
Install the (2) 4x40 screws back to attach the Battery Compartment Lid to the Inside
Plate Assembly.
48
Maintenance Record
Table of Contents
Advertisement
Table of Contents
