Jayco Precept 2018 Owner's Manual page 66

Section 4: Vehicle Operation
NOTE: If the awning is equipped with the Direct Response
system, this procedure is not applicable. See the manufacturer's
owner's manual for additional information.
Locate and separate the quick disconnects located in the motor arm channel. Position the
wires from the motor on the outside of the channel.
7. Attach jumper wires to the motor wires. Connect the other ends of the jumper leads
to the 10VDC–14VDC source. If the awning moves in the
wrong direction, reverse the leads.
8. Maintain contact throughout the retraction process.
9. Hold the wires from the motor on the outside of the channel
while closing the awning. This provides access for opening
the awning.
10. When power is restored, use the jumper wires and extend
the awning to access the cable disconnects. Re-attach the
disconnects and secure in the arm channel.
Additional Awning Operation Information
When rolled out, the fabric may "bounce" creating a wave
like motion in the canopy fabric. This can creates the
appearance of moving jerkily.
Vinyl may have a tendency to "cling" to the when not used for an extended period of
time. Open and close the awning in short bursts 2 or 3 times, the awning will then open
normally.
If the awning does not operate, contact the Carefree Service Center.
carefreeofcolorado.com for a listing of service centers.
64
Maintenance Record Table of Contents
See www.