Front Passenger Door Request Switch - Mazda 3 2018 Owner's Manual

Before Driving
Doors and Locks

Front passenger door request switch

To unlock all doors and the liftgate/trunk
lid, press the request switch. A beep sound
will be heard twice and the hazard
warning lights will flash twice.
NOTE
The system can be set to unlock all

doors by performing a single operation.
Refer to Personalization Features on
page 9-12.
Use the following procedure to change
the setting.
1. Switch the ignition off and close all
of the doors and the liftgate/trunk
lid.
2. Open the driver's door.
3. Within 30 seconds of opening the
driver's door, press and hold the
UNLOCK button on the key for 5
seconds or longer (the sound of the
doors locking/unlocking can be
heard).
After this, the system switches the
setting of pressing the driver's
request switch once or twice to
unlock all doors and the liftgate/
trunk lid each time the UNLOCK
button is pressed (the sound of the
doors locking/unlocking can be
heard).
3-14
Mazda3_8GE4-EA-17F_Edition1
4. The setting change is completed by
doing any one of the following:
Switching the ignition to ACC or

ON.
Closing the driver's door.

Opening the liftgate/trunk lid.

Not operating the key for ten

seconds.
Pressing any button except the

UNLOCK button on the key.
Pressing a request switch.

Confirm that all doors and the liftgate/

trunk lid are securely locked.
For the liftgate/trunk lid, move it
without pressing the electric liftgate/
trunk lid opener to verify that the
liftgate/trunk lid has not been left ajar.
All doors and the liftgate/trunk lid

cannot be locked when any door or the
liftgate is open.
It may require a few seconds for the

doors to unlock after the request switch
is pressed.
A beep sound is heard for confirmation

when the doors and the liftgate/trunk lid
are locked/unlocked using the request
switch. If you prefer, the beep sound can
be turned off.
The volume of the beep sound can also
be changed. Refer to Personalization
Features on page 9-12.
Use the following procedure to change
the setting.
1. Switch the ignition off and close all
of the doors and the liftgate/trunk
lid.
2. Open the driver's door.
2017-4-7 11:59:21