Mazda 3 2018 Owner's Manual page 97

NOTE
Function number 3 in the following

table is the factory setting for your
vehicle.
There are only a total of five auto lock/

unlock settings available for automatic
transaxle vehicles, and three for manual
transaxle vehicles. Be sure to press the
unlock side of the driver's door-lock
switch the correct number of times
according to the selected function
number. If the switch is mistakenly
pressed six times on an automatic
transaxle vehicle or four times on a
manual transaxle, the procedure will be
cancelled. If this occurs, start the
procedure from the beginning.
Function
number
The auto door-lock function is disa-
1
bled.
All the doors and the liftgate/trunk lid
lock automatically when the vehicle
2
speed is about 20 km/h (12 mph) or
more.
All the doors and the liftgate/trunk lid
lock automatically when the vehicle
3 (Factory speed is about 20 km/h (12 mph) or
Setting) more. All the doors and the liftgate/
trunk lid unlock when the ignition is
switched from ON to Off.
(Automatic transaxle vehicles only)
When the ignition is switched ON
and the shift lever is shifted from park
4
(P) to any other gear position, all the
doors and the liftgate/trunk lid lock
automatically.
Mazda3_8GE4-EA-17F_Edition1
*1
Function
Doors and Locks
Function
Function
number
(Automatic transaxle vehicles only)
When the ignition is switched ON
and the shift lever is shifted from park
(P) to any other gear position, all the
doors and the liftgate/trunk lid lock
5
automatically.
When the shift lever is shifted to park
(P) while the ignition is switched ON,
all the doors and the liftgate/trunk lid
unlock automatically.
*
1 Other settings for the auto door lock function are
available at an Authorized Mazda Dealer. For
details consult an Authorized Mazda Dealer.
Refer to Personalization Features on page 9-12.
Settings can be changed using the
following procedure.
1. Safely park the vehicle. All doors must
remain closed.
2. Switch the ignition ON.
3. Press and hold the lock side of the
driver's door-lock switch within 20
seconds of switching the ignition ON,
and make sure a beep sound is heard
about eight seconds afterwards.
4. Refer to the auto lock/unlock function
setting table, determine the function
number for the desired setting. Press
the unlock side of the driver's
door-lock switch the same number of
times as the selected function number
(Ex. If you select function 2, press the
unlock side of the switch only 2 times).
5. Three seconds after the function
setting has been changed, a beep sound
will beep in the amount of the selected
function number. (Ex. Function
number 3 = 3 beep sounds)
Before Driving
*1
3-17
2017-4-7 11:59:21