Child-Restraint System Suitability for Various Seat
(Mexico)
Provided information in the table shows your child-restraint system suitability for various
seating position. For installation suitability of other manufacturer child-restraint system,
carefully consult the manufacturer's instructions which accompany the child-restraint
system.
When installing a child-restraint system, the following points must be observed:
If the child-restraint system does not fit into the seatback because of the head restraint,
adjust the head restraint or remove the head restraint so that the child-restraint system fits
into the seatback. However, when installing a backless booster seat, always install the
vehicle head restraint to the seat where the backless booster seat is installed.
Refer to Head Restraints on page 2-10.
When installing a child-restraint system to the rear seat, adjust the front seat position so
that the front seat does not contact the child-restraint system.
Refer to Seat Operation on page 2-5.
When installing a child-restraint system came equipped with a tether, remove the head
restraint.
Refer to Head Restraints on page 2-10.
LATCH lower anchor-secured child-restraint systems
When installing a child-restraint system to the rear seat, refer to the child-restraint system
manufacturer's instructions and the Using LATCH Lower Anchor on page 2-40.
Mass group
Carrycot
GROUP 0 Up to 10
kg (up to 22 lb)
GROUP 0
Up to
13 kg (up to 29 lb)
Mazda3_8GE4-EA-17F_Edition1
Positions Table
Vehicle LATCH po-
Size
Fixture
sitions
Class
Rear seat (out-
board)
F
ISO/L1
G
ISO/L2
(1)
E
ISO/R1
(1)
E
ISO/R1
D
ISO/R2
C
ISO/R3
(1)
Seat Positions
Rear seat (center)
X
X
X
X
X
X
IL
X
X
X
IL
X
IL
X
IL
X
X
X
Essential Safety Equipment
Child-Restraint
Front passenger
seat (outboard)
X
X
X
X
X
X
X
X
X
2-27
2017-4-7 11:59:21