Page 1
Version 1.0 Last Revised October 13, 2017 All contents in this manual are copyrighted by JAVAD GNSS. All rights reserved.The information contained herein may not be used, accessed, copied, stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express...
Page 3
JAVAD GNSS products. It is designed to as- EDITORIAL ERRORS OMISSIONS sist owners with the use of JLink LTE and its use is CONTAINED HEREIN; NOR FOR INCIDENTAL subject to these terms and conditions (the “Terms and OR CONSEQUENTIAL DAMAGES RESULTING Conditions”).
Page 4
Consult the dealer or an experienced radio/television technician for additional suggestions. SAFETY – Improper use of JLink LTE can lead to injury to persons or property and/or malfunction of the Any changes or modifications to the equipment not expressly approved by the party responsible for product.
Page 5
If you have a problem and cannot find the informa- tion you need in the product documentation, contact your local dealer. Alternatively, request technical sup- port using the JAVAD GNSS World Wide Web site at: www.javad.com To contact JAVAD GNSS Customer Support use the QUESTIONS button available on the www.javad.com.
GNSS equipment to RTN, where no cell phone cover is available. JLink LTE devices may contain 1 JLink LTE is a family of devices designed for or- W either UHF (406 to 470 MHz) or VHF (138-174 ganizing a local network between different devices...
Page 7
10.1.10.1:8080. and Internet access availability. More detailed con- • via Ethernet: JLink LTE LAN static IP adress is nection status you can check in Status/GSM tab see below. 192.168.0.200 and network mask is 255.255.255.0.
Page 8
After reboot device is ready for telnet connection to serial port using “Ser2Net” as login and “jlinklte” as password. For connecting to JLink LTE serial port needed to setup with following parameters: ▪ Baudrate 115200 ▪ Parity none ▪...
Page 9
NTRIP Client to Serial Port The following are the steps of configuration of JLink LTE: 1. Connect to JLink LTE via web interface as de- scribed above. 2. Configure the Cellular (GSM ): • In the Communication/GSM tab set the PIN code and APN parameters (if necessary);...
Page 10
UHF channel (in Satel mode) to Serial Port The following are the steps of configuration of JLink LTE: 1. Connect to JLink LTE via web interface as de- scribed above. 2. UHF configuration in Satel mode: ◦ In the Communication/UHF Int. tab: •...
Page 11
Figure 19. JLink LTE UHF Int. Status tab Figure 17. JLink LTE UHF parameters configuration tab 3. Setup Serial Port ◦ In the Communication/Power Management tab ac- ◦ In the Communication/Advanced tab select “Serial tivate the UHF interface: port as” parameter as Terminal.
Page 12
1110-1119 ports will be redirected to Wi- • WiFi client which IP address is 10.1.10.110. Data packets received by 1120-1129 ports will be redirect- ed to WiFi client which IP address is 10.1.10.120. • To receive redirected data of JLink LTE the Tri- www.javad.com...
Page 13
(e.g, 10.1.10.1), and WLAN Network Mask (e.g, fault gateway is 10.1.10.1). 255.255.255.0). • Set the AccessPoint parameters: WLAN Access Point ID (enter SSID of JLink LTE), WLAN AP mode(wpa). • Set the WPA parameter: WLAN WPA Passphrase (enter passphrase of JLink LTE).
Transmitter Output Power 1W (+30 dBm) Data Rate of Radio Interface 64000 bps Communication Mode Half duplex, simplex, repeater (USA/Australia) Data Rate Radio Interface (EU) 9600 bps Transmitter Output Power 1W (+30 dBm) Communication Mode Half duplex, simplex, repeater www.javad.com...
Page 15
* The operating temperature of Li-Ion batteries is -20 ° C to+45° C ** The storage temperature range of Li-Ion batteries is -20 ° C to +60° C Pinout of JLink LTE power and communication port Pin # Signal Name I/O...
Page 16
1- UHF/VHF/ISM Transceiver / Beacon receiver, cellular module, GPS receiver, Bluetooth, WiFi, Ethernet, USB and Serial port. 2 - Variant 1 with battery. 3 - Cellular module, GPS receiver, Bluetooth, WiFi, Ethernet, USB and Serial port. 4 - Variant 3 with battery. www.javad.com...
• Contrary to applicable laws, rules, and regula- apparatus. tions. Warning: The JLink LTE receiver should never be used in dangerous environments. Use in rain or snow for a limited period is permitted. www.javad.com...
The purchaser’s sole remedy shall be replacement as provided above. In no event shall JAVAD GNSS be lia- ble for any damages or other claim including any claim for lost profits, lost savings or other incidental or con- sequential damages arising out of the use of, or inability to use, the product.
Need help?
Do you have a question about the JLink LTE and is the answer not in the manual?
Questions and answers