Special Function; Programming Password; Lease Function - Leixen UV-52 User Manual

Special Function

Programming Password

A programming password can be pre-set to the
transceiver through the software. When a password
pre-set to a transceiver, the password should be input
in the software, or the communication between the
computer and the transceiver would be failed.

Lease Function

The Lease function can be set to limit how long a
transceiver can be used. When the Lease Time expires,
the transceiver will no longer operate, and the
indicator LED will light continuously red. At this
point, the user may only turn the transceiver power off.
This function can only be reset with programming
software.
Remaining time: You can set the transceiver to
display the time remaining for the transceiver lease. If
the Lease function is enabled using the programming
software, the startup display can be set to display the
remaining lease time.
Lease Time: You may set the transceiver Lease Time
through the programming software. The valid Lease
Time range is from 1 minute to 255 days 24 hours,
and 59 minutes.