Menu+3+2]Roger(Roger); Menu+3+3/4]Offset Frequency; Type) - Leixen UV-52 User Manual

32 ．

[ MENU+3+2]Roger(Roger)

The transceiver can send a "Roger beep" to mark the
end of a transmission. Select "ON" to enable this
feature, or "OFF" to disable it. The default setting is
OFF.
33/34 ． [MENU+3+3/4]Offset Frequency (RPT
SET/RPT TYPE)
You can set a channel to use different receive and
transmit frequencies. This is most useful for operating
through a repeater, which receives on one frequency
and then retransmits on another frequency from a
higher antenna. This effectively provides systems
using the repeater with greater communication range
than they would achieve alone.
Setting these separate frequencies is accomplished by
setting Menus 33 and 34. First, you will need to set
the offset amount, which is the difference between the
receive and transmit frequencies. The transceiver can
accept offset values from 0.000 to 399.995 MHz.
In VFO Mode, select Menu 34. Enter the offset value
using the number keys, or by using the "▲▼" keys.
Default: UHF(5MHz), VHF(0.6MHz).
Select the offset direction using Menu 33. Using the
"▲▼" keys, select "RPT+" (positive offset, the
transmit frequency is higher than the receive
frequency), "RPT-" (the transmit frequency is lower
than the receive frequency), or "SING" (no offset,
only a single frequency is used).