Leixen UV-52 User Manual page 42

for five seconds, then scanning will continue, even
if the channel is still active.
Carrier operated (CO): Scanning stops when an
active channel is encountered. Scanning resumes
after two seconds of channel inactivity.
The default setting is "TO".
Note: Press any key except ▲ or ▼ to stop scanning.
Scan range: You may select two different scanning
ranges:
VFO frequency scan: All frequencies on the band
will be scanned.
In VFO mode, press "SCAN(#)" key to start
scanning. The scan will begin at the current
frequency and continue up the band. To reverse the
scan direction, press the "▼" key. Scan up the band
again by using the "▲" key. Press any other key to
stop scanning.
MR/CH scan: Scan only programmed memory
channels in this mode. From MR/CH mode, press
"SCAN(#)" keys to start scanning, scanning begins
on the current channel and scans up to higher
channel numbers. To reverse the scan direction,
press the "▼" key. Scan up the band again by
using the "▲" key Press any other key to stop
scanning.
Note:
a) Each memory channel can be set to be blocked
from scan through Scan Add. Press "ADD(0)"