Installing Parameterization Interfaces - Siemens SIMATIC S7-300 FM 350-1 Manual

Programming FM 350-1

4.1 Installing Parameterization Interfaces

4.1 Installing Parameterization Interfaces
Supplementary conditions
The following conditions apply for transferring parameterization data to the CPU:
● STEP 7 is installed correctly on your programming device.
● The programming device is connected correctly to the CPU
● The CPU is in STOP
Note
You must not plug in or remove any S7-300 modules during data exchange over the MPI!
Installing the Parameterization Interfaces
To install the configuration package:
1. Place the supplied CD in the CD drive of your programming device / PC.
2. Start the program "Setup.exe".
3. Follow the operating instructions provided by the installation program.
Important information about the installation can be found in the readme file.
Result
The components of the configuration package are installed in the following directories:
● SIEMENS\STEP7\S7LIBS\FMx501LIB: FCs, UDTs
● SIEMENS\STEP7\S7FCOUNT: Configuring software, Readme, Online help
● SIEMENS\STEP7\EXAMPLES:Examples
● SIEMENS\STEP7\S7MANUAL\S7FCOUNT: Getting Started, manuals
Note
If you selected a directory other than SIEMENS\STEP7 when you installed STEP 7, that
directory will be entered.
36
FM 350-1 Counter module
Manual, 05/2011, A5E03648639-01