Siemens SIMATIC S7-300 FM 350-1 Manual page 63

Offset to the start Parameter
address
Byte 14 –
–
–
–
SET_DO1
SET_DO0
CTRL_DO1
CTRL_DO0
Byte 15 –
C_DOPARA
RES_ZERO
–
T_CMP_V2
T_CMP_V1
L_PREPAR
–
Do not set this bit at the same time as bit 1, 2 or 3 of byte 15.
1)
Do not set this bit at the same time as bit 6 of byte 15.
2)
FM 350-1 Counter module
Manual, 05/2011, A5E03648639-01
Assignment
Bit 7: Reserve = 0
Bit 6: Reserve = 0
Bit 5: Reserve = 0
Bit 4: Reserve = 0
Bit 3: Control bit DO1
Bit 2: Control bit DO0
Bit 1: Enable DO1
Bit 0: Enable DO0
Bit 7: Reserve = 0
Bit 6: Change function DO0
1)
Bit 5: Reset status bits of overflow, underflow and end of measurement
Bit 4: Reserve = 0
Bit 3: Change update time
2)
Bit 2: Load high limit
2)
Bit 1: Load low limit
2)
Bit 0: –
Programming the FM 350-1
5.7 Programming FM 350-1 without FCs
63