Starter Motor - Yanmar 3TNV82A-B Service Manual

SAFETY
CAUTION
If any problem is noted during the visual
check, the necessary corrective action
should be taken before you operate the
engine.
CAUTION
NEVER hold the key in the START
position for longer than 15 seconds or
the starter motor will overheat.
CAUTION
Make sure the engine is installed on a
level surface. If a continuously running
engine is installed at an angle greater
than (IDI = 25°, DI = 30°) in any direction
or if an engine runs for short periods of
time (less than three minutes) at an
angle greater than (IDI = 30°, DI = 35°) in
any direction, engine oil may enter the
combustion chamber causing excessive
engine speed and white exhaust smoke.
This may cause serious engine damage.
3-14
Observe the following environmental
operating conditions to maintain engine
performance and avoid premature
engine wear:
0000021en • Avoid operating in extremely dusty
• Avoid operating in the presence of
• Avoid operating in a corrosive
0000007en
• NEVER install the engine in a
• NEVER expose the engine to the rain.
Observe the following environmental
operating conditions to maintain engine
performance and avoid premature
engine wear:
• The standard range of ambient
0000010enTNV
• If the ambient temperature exceeds
• If the ambient temperature is below
• Contact your authorized Yanmar
CAUTION
conditions.
chemical gases or fumes.
atmosphere such as salt water spray.
floodplain unless proper precautions
are taken to avoid being subject to a
flood.
CAUTION
temperatures for the normal operation
of Yanmar engines is from +5°F (-15°C)
to +113°F (+45°C).
+113°F (+45°C) the engine may
overheat and cause the engine oil to
break down.
+5°F (-15°C) the engine will be hard to
start and the engine oil may not flow
easily.
industrial engine dealer or distributor
if the engine will be operated outside
of this standard temperature range.
TNV DI Service Manual
Safety Precautions
0000003en
0000065en