Yanmar 3TNV82A-B Service Manual page 345

Starter Motor
(6)
Figure 11-4
3. Remove the two M5 through bolts
(Figure 11-4, (4)). Separate the rear cover
(Figure 11-4, (2)), field coil assembly
(Figure 11-4, (5)) with the armature assembly
(Figure 11-4, (6)) from the gear housing
(Figure 11-4, (7)).
4. Pull the brush springs up using a brush spring
puller. On the negative (-) side, bring the brush
spring into contact with the side of the brush for
lifting from the commutator surface. On the
positive (+) side, remove the brush from the
brush holder assembly (Figure 11-5, (1)).
(1)
Figure 11-5
5. Remove the brush holder assembly
(Figure 11-6, (1)) from the armature assembly
(Figure 11-6, (3)).
TNV DI Service Manual
(7)
(4)
(1)
(5) (3) (2)
0000105A
0000106A
(2)
Figure 11-6
6. Pull the armature assembly (Figure 11-6, (3))
out from the field coil assembly
(Figure 11-6, (2)).
7. Remove the two M6 bolts (Figure 11-7, (1))
retaining the magnetic switch assembly
(Figure 11-7, (2)) to the gear housing. Remove
the magnetic switch assembly, dust cover(s)
(Figure 11-7, (3)) and torsion spring
(Figure 11-7, (4)) from the gear housing.
(2) (4)
Figure 11-7
8. Disassemble the dust cover (Figure 11-8, (3))
and shift the lever (Figure 11-8, (4)) from the
gear housing.
(1)
Figure 11-8
STARTER MOTOR
(1)
(3)
(1)
(3)
0000108A
(2)
0000109A
11-11