ALTERNATOR
9. Remove the stator assembly
(Figure 12-10, (1)) from the front frame
housing.
Figure 12-10
10. If it is necessary to replace the bearing
(Figure 12-10, (2)) in the front frame housing,
remove the four bolts (Figure 12-10, (3))
securing the plate (Figure 12-10, (4)) to the
front frame housing. Remove the plate. Use a
puller to remove the bearing. Discard the
bearing.
11. If it is necessary to replace the bearing
(Figure 12-11, (1)) in the rear frame housing,
use a puller to remove. Discard the bearing.
Remove the bearing cover (Figure 12-11, (2))
and two thrust washers (Figure 12-11, (3)).
12-14
4
3
2
1
Reassembly of Alternator
0000259A
1. If removed, reinstall the two trust washers
3
2
1
Figure 12-11
(Figure 12-12, (3)) and bearing cover
(Figure 12-12, (2)) in the rear frame housing.
Lubricate the outside diameter of a new bearing
(Figure 12-12, (1)). Press the bearing into the
rear frame housing.
3
2
1
Figure 12-12
TNV DI Service Manual
Alternator
0000260A
0000260A