Yanmar 3TNV82A-B Service Manual page 37

Safety Precautions
CAUTION
If the waste valve does not meet
specifications, replace the turbocharger
or have it repaired by a qualified repair
facility.
CAUTION
• NEVER attempt to modify the engine's
design or safety features such as
defeating the engine speed limit
control or the diesel fuel injection
quantity control.
• Modifications may impair the engine's
safety and performance
characteristics and shorten the
engine's life. Any alterations to this
engine may void its warranty. Be sure
to use Yanmar genuine replacement
parts.
CAUTION
Identify all parts and their location using
an appropriate method. It is important
that all parts are returned to the same
position during the reassembly process.
CAUTION
Each pressure adjusting shim removed
or added changes the pressure
threshold by approximately 275 psi
(1.9 MPa, 19 kgf/cm
shims increases the threshold pressure.
Removing adjusting shims reduces the
pressure threshold.
TNV DI Service Manual
0000078en
0000079en
0000080en
2 ). Adding adjusting
0000081en
CAUTION
Do not rotate the crankshaft with the
injection pump removed.
CAUTION
Keep the piston pin parts, piston
assemblies, and connecting rod
assemblies together to be returned to
the same position during the
reassembly process. Label the parts
using an appropriate method.
CAUTION
Do not allow the honing tool to operate
in one position for any length of time.
Damage to the cylinder wall will occur.
Keep the tool in constant up-and-down
motion.
CAUTION
Any part which is found defective as a
result of inspection or any part whose
measured value does not satisfy the
standard or limit must be replaced.
CAUTION
Any part determined to not meet the
service standard or limit before the next
service, as determined from the state of
current rate of wear, should be replaced
even though the part currently meets the
service standard limit.
SAFETY
0000083en
0000088en
0000090en
0000119en
0000120en
3-21