Furuno FEA-2107-BB Installation Manual page 79

• GyroNmeaCh
• PminRadius
For proper track control, software of AEU511 must be "SEM200 Version Aeu2_3 Compiled
6-5-2003 15:37" and MPI31 must be "MIP2 Version Mip2 Compiled 7-5-2003 14:55".
Notes (Emergency instructions for cases when software of AEU511 or MIP31 is older
version.)
• Parameter "ctsdef" requires careful special attention.
• When software of AEU511 is older than "SEM200 Version Aeu2_3 Compiled 13-2-2002"
• ctsdef 0
cts=hsc when leaving remote (continue turn)
• When software of AEU511 is newer or equal to "SEM200 Version Aeu2_3 Compiled
13-2-2002"
• ctsdef 2
turn/linear bit control behaviour. For turn, cts=hsc when leaving remote
(continue turn). For linear, cts=hdg; when leaving remote (steady as she goes).
Note also that if software of AEU511 electronic unit is newer or equal to "SEM200 Version
Aeu2_3 Compiled 13-2-2002", then software of MIP panel must be newer or equal to "MIP2
Version Mip2 Compiled 7-3-2002 13:33".
x (Serial channel for gyro)
xx (Minimum available radius. Must be equal to
ECDIS parameter.)
3. ADJUSTMENTS
3-37