Safety Instructions - Furuno FEA-2107-BB Installation Manual

SAFETY INSTRUCTIONS

WARNING
Do not open the equipment
unless totally familiar with
electrical circuits and
service manual.
Only qualified personnel
ELECTRICAL
should work inside the
SHOCK
equipment.
HAZARD
Turn off the power at the mains switch-
board before beginning the installation.
Fire, electrical shock or serious injury can
result if the power is left on or is applied
while the equipment is being installed.
Do not install the monitor unit, processor
unit or control unit where they may get
wet from rain or water splash.
Water in the units can result in fire, electrical
shock, or damage the equipment.
Be sure that the power supply is
compatible with the voltage rating of
the equipment.
Connection of an incorrect power supply
can cause fire or damage the equipment .
Use only the specified power cable.
Fire or damage to the equipment can result
if a different cable is used.
WARNING
The PCI-951/PCG820 board is equipped
with a litium battery. The lithium battery
shouldbe replaced only in the factory.
There is a danger of explosion if the wrong
type of battery is used for replacement.
CAUTION
Attach securely protection
earth to the ship's body.
The protection earth
(grounding) is required to the
AC power supply to prevent
electrical shock.
Observe the following compass safe
distances to prevent deviation of a
magnetic compass:
Processor
Unit (EC-1000C) 1.65 m
LAN Adapter
(EC-1010)
B Adapter
(EC-1020)
Control Unit
(RCU-018)
Control Unit
(RCU-015)
Control Unit
(RCU-016)
Monitor Unit
(MU-201CE-DV15)
Monitor Unit
(MU-231CE-DV15)
Monitor Unit
(MU-190)
Monitor Unit
(MU-231)
Switching HUB
(HUB-100)
i
Standard Steering
compass compass
1.05 m
1.05 m 0.70 m
0.80 m 0.50 m
0.30 m
0.30 m
0.95 m
0.60 m
0.65 m 0.45 m
2.25 m 1.40 m
2.55 m 1.55 m
1.05 m
1.65 m
0.55 m
0.85 m
0.60 m
1.00 m