System Configurations - Furuno FEA-2107-BB Installation Manual

SYSTEM CONFIGURATIONS

The ECDIS EC1000 Workstation displays electronic seachart and operates as user
interface for the system. The ECDIS processor is connected to various sensors, and
performs navigation calculations and route monitoring. Connections to interfaces are
typically made with a LAN (Local Area Network) Adapter. The ECDIS processor can be
used for both route planning and route monitoring. If required, there can be additional
identical ECDIS EC1000C Workstation(s) connected to the same LAN to share the tasks of
the ECDIS. If the system incorporates more than one ECDIS EC1000C Workstation, one or
more workstation(s) can be used as a user interface (with "full" usage rights) and one or
more workstation(s) may be used as planning stations (usage rights as "planning"). If the
system has two or more Workstations connected together as multi-workstations, the system
keeps data on the workstations harmonised and also tracks selections and settings made
on any workstation.
Typically there can be the following kinds of workstation configuration:
Mode as Single, only one workstation is used in the system.
Mode as Multi, two or more workstations are used in the system where usage rights and
sensor source of workstations can be changed by the user.
For more information, see the operator's manual.
One workstation
ECDIS Monitor
MU-201CE (FEA-2107)
MU-190 (FEA-2107-D)
MU-231CE (FEA-2807)
100-230 VAC
MU-231 (FEA-2807-D)
DVI or RGB
CALCOMP
DRAWING-
BOARD III
DIGITIZER
FAR-2xx7 series
100-230 VAC
Conning Monitor
MU-201CE (FEA-2107)
MU-190 (FEA-2107-D)
MU-231CE (FEA-2807)
100-230 VAC
MU-231 (FEA-2807-D)
DVI or RGB
HUB-
(WORKSTATION)
ECDIS PROCESSOR
100-230 VAC
EC1000C
RADAR OVERLAY PCB
Control Unit
RCU-018
or
TB Control Unit
RCU-015FEA
Remote Control Unit
RCU-016
ALARM OUTPUT
(ECDIS SYSTEM FAIL)
L AN ADAPTER
EC-1010
Rectifier
PR-62
24 VDC
100/230 VAC
LAN ADAPTER
100
EC-1010
Rectifier
24 VDC
100/230 VAC
B ADAPTER
EC-1020
Rectifier
24 VDC
PR-62
100/230 VAC
RADAR
SWITCH
PRINTER
(USB)
iv
ARPA RADARS
POSITION-FIXING EQUIPMENT
TRACK PILOT
LOG/DUAL AXIS LOG
AIS
GYRO COMPASS
POSITION-FIXING EQUIPMENT
ENGINE CONTROL
ECHOSOUNDE R
WIND SENSOR
WATER TEMP. METER
AMWSS (Alarm Monitoring
Watch Safety System)
PR-62
GYRO COMPASS
(SYNCHRO, STEPPER)
LOG (200P/NM)
ANALOG INPUT (8 CHANNEL S)
ALARM OUTPUT (8 CHANNEL)
RADAR 1 (VIDEO, HL , AZ)
DAR 2 (VIDEO, HL , AZ)
RA
OPTION
EXTERNAL
DEVICE