Application-Specific Commissioning; Commissioning" Quick Setup Menu - Endress+Hauser Proline Promag 53 Operating Instructions Manual

6 Commissioning
!
84
6.2

Application-specific commissioning

In the case of measuring devices without a local display, the individual parameters and functions
must be configured via the configuration program, e.g. ToF Tool - Fieldtool Package. If the measur-
ing device is equipped with a local display, all the important device parameters for standard opera-
tion can be configured quickly and easily by means of the "Commissioning" Quick Setup menu.
• Quick Setup "Commissioning", → Page 4 ff.
• Quick Setup "Pulsating flow", → Page 86 ff.
• Quick Setup "Batching", → Page 89 ff.
6.2.1

"Commissioning" Quick Setup menu

Note!
• The display returns to the cell SETUP COMMISSIONING (1002) if you press the ESC key
combination during parameter interrogation. The stored parameters remain valid.
• The "Commissioning" Quick Setup must be carried out before one of the Quick Setups explained
below is run.
m Only units not yet configured in the current Setup are offered for selection in each cycle.
The unit for mass, volume and corrected volume is derived from the corresponding flow unit.
n The "YES" option remains visible until all the units have been configured.
"NO" is the only option displayed when no further units are available.
o Only the outputs not yet configured in the current Setup are offered for selection in
each cycle.
p The "YES" option remains visible until all the outputs have been parameterized.
"NO" is the only option displayed when no further outputs are available.
q The "automatic parameterization of the display" option contains the following
basic settings/factory settings:
YES: Main line = Mass flow; Additional line = Totalizer 1;
Information line =
NO: The existing (selected) settings remain.
r The QUICK SETUP BATCHING is only available when the optional software package
BATCHING is installed.
Operating/system conditions
Proline Promag 53
Endress+Hauser