Table of Contents
Advertisement
Product at a Glance
Use on Dimmer
Outdoor Use
Sound-Active
DMX
Master/Slave
Safety Notes
•
ONLY connect this product to a grounded and protected circuit.
•
DISCONNECT from power before cleaning or replacing the fuse.
•
DO NOT look at the light source when the product is on.
•
Make sure the power cord is not crimped or damaged.
•
Never disconnect this product from power by pulling on the cord.
•
When mounting this product overhead, ALWAYS use a safety cable.
•
DO NOT allow flammable materials close to the product when it is operating.
•
DO NOT touch the product's housing when it is on because it will be hot.
•
The voltage of the outlet to which you are connecting this product must be within the range
stated on the decal or rear panel of the product.
•
This product is for indoor use only! (IP20) To prevent risk of fire or shock, do not expose
this product to rain or moisture.
•
Always mount this product in a location with adequate ventilation, at least 20 in (50 cm)
from adjacent surfaces.
•
Be sure that no ventilation slots on the unit's housing are blocked.
•
Never connect this product to a dimmer or rheostat.
•
Replace the fuse with the same type and rating.
•
Never carry the product by the power cord. Use only the handle to carry this product.
•
The maximum ambient temperature is 104 °F (40 °C). Do not operate this product at higher
temperatures.
•
In the event of a serious operating problem, stop using immediately.
•
DO NOT open this product. It contains no user-serviceable parts.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Keep this User Manual for future use. If you sell the product to someone else, be sure that
they also receive this document.
Page 2 of 20
Auto Programs
Auto-ranging Power Supply
Replaceable Fuse
User-Serviceable
Intimidator Beam 355 IRC User Manual Rev. 1
B
Y
B
EFORE
OU
EGIN
Advertisement
Table of Contents
