Table of Contents
Advertisement
O
PERATION
Configuration (DMX)
The Intimidator Beam 355 IRC works with a DMX controller. Information about DMX is in the CHAUVET
DMX Primer, which is available from the Chauvet website
DMX_Primer_rev05_WO.pdf.
Starting Address
When selecting a starting DMX address, always consider the number of DMX channels the selected DMX
mode uses. If you choose a starting address that is too high, you could restrict the access to some of the
product's channels.
The Intimidator Beam 355 IRC uses up to 14 DMX channels, which defines the highest configurable
address to 499.
If you are not familiar with the DMX protocol, download the DMX Primer from www.chauvetdj.com.
To select the starting address, do the following:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to select Address.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select the starting address, from 001–512.
5.
Press <ENTER>.
DMX Personalities
The Intimidator Beam 355 IRC has two DMX personalities, a 14-channel personality, and a 8-channel
personality.
To choose which DMX personality to use, follow the steps below:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to select Run Mode.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select DMX.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select the DMX personality, from 14CH or 08CH.
7.
Press <ENTER>.
Gobos
0~7
32~39
Intimidator Beam 355 IRC User Manual Rev. 1
8~15
16~23
40~47
48~63
http://www.chauvetlighting.com/downloads/
24~31
Page 7 of 20
Advertisement
Table of Contents
