Smartrise Menu Definitions - Smartrise F220 Equipment Installation Manual

SMARTRISE MENU DEFINITIONS

 MAIN MENU | STATUS |
 I/O

INPUT GROUPS

Displays the real time status of any programmed input.
 MAGNETS

DZ1 Top/Bottom for all floors

Displays the precise location, in feet and in counts, of the Top and Bottom on every programmed
DZ magnet.
 SWITCHES

HOISTWAY SWITCHES (UET/DET)

Displays the precise location, in feet and in counts, of the UET and DET switches.
 HALL BOARDS

ACCESS BOTTOM

Displays the communication and button status of the Access Bottom Hall Board.

ACCESS TOP

Displays the communication and button status of the Access Top Hall Board.

FIRE RECALL

Displays the communication and button status of the Fire Recall Hall Board.

EMS

Displays the communication and button status of the EMS Hall Board.

HALL CALL BOARDS (F/R)

Displays the communication and button status of the Riser Hall Board.

HALL LANTERNS (F/R)

Displays the communication and button status of the Lantern Hall Board.
 MAIN MENU | FAULTS |
 ACTIVE

Displays current active faults that are preventing the car from running.
 LOGGED

Displays the 15 latest faults stored in the board's non-volatile memory with the most recent faults at
the bottom.
 CLEAR LOG

Clears the fault log history.
 MAIN MENU | SETUP | SPEEDS & SLOWDOWNS |
 CONTRACT

Sets the Contract speed the car should or is actually running at. See actual car speed next to "FPM" to
see if this value is correct.
 INSPECTION SPEED

Sets the speed the Controller uses for all inspection modes. By code this speed may not exceed 150
FPM.
 LEVELING SPEED

Sets the speed the Controller uses while leveling in a Door Zone.
 RELEVELING SPEED

Sets the speed the Controller uses while releveling in a Door Zone.
206