General index 1. INTRODUCTION. 5.3.3. Connection of external batteries [extended back up times] -B1-. 5.3.4. Connection of main input earth terminal and the earth bonding 1.1. ACKNOWLEDGEMENT LETTER. terminal 2. INFORMATION FOR SAFETY. 5.3.5. Terminals for EPO (Emergency Power Off). 2.1.
Page 3
9. ANNEXES. 9.1. GENERAL TECHNICAL SPECIFICATIONS. 9.2. GLOSSARY. USER'S MANUAL SLC TWIN PRO2 UNINTERRUPTIBLE POWER SUPPLY (UPS)
We remain at you entire disposal for any further information or any query you should wish to make. Yours sincerely. SALICRU The equipment here described can cause important physical •...
WebSite, or the CD-ROM or Pen Drive in a safe place and with easy access, for further questions that could arise. The following terms are used in the document indistinctly to be re- ferred to: «SLC TWIN PRO2, TWIN PRO2, TWIN, PRO2, equipment, • unit o UPS».- Uninterruptible Power Supply.
The manufacturers responsibility is excluded in the event of any modification or intervention in the product by the customer’s side. WARNING!: SLC TWIN PRO2 0.7.. 3 kVA. This is a category C1 UPS product. The use of this equipment is not suitable for life support...
Fig. 1. Front view from 0.7 to 1 kVA models. Models from 1.5 and 3 kVA -standard- Models from 1.5 and 3 kVA -B1- Fig. 2. Front view from 1,5 to 3 kVA models. USER'S MANUAL SLC TWIN PRO2 UNINTERRUPTIBLE POWER SUPPLY (UPS)
Input socket Input breaker Input socket protection Extended Protection cover autonomy for smart slot connector Models from 1.5 and 2 kVA -standard- Models from 1.5 and 2 kVA -B1- Fig. 4. Rear panel IEC view from 1.5 and 2 kVA. SALICRU...
Protection cover autonomy for smart slot connector Models from 0.7 and 1 kVA -standard- Models from 0.7 and 1 kVA -B1- Fig. 6. Rear panel schuko view from 0.7 and 1 kVA. USER'S MANUAL SLC TWIN PRO2 UNINTERRUPTIBLE POWER SUPPLY (UPS)
Page 10
Output sockets Input breaker protection Input socket Input breaker Input socket protection Protection cover Extended for smart slot autonomy connector Models from 3 kVA -standard- Models from 3 kVA -B1- Fig. 8. Rear panel schuko view from 3 kVA. SALICRU...
Connector to UPS (extended (extended autonomy) autonomy) Battery module for models 0.7 and 1 kVA Battery module for models 1.5 and 3 kVA Fig. 10. Rear view battery module for extended autonomy. USER'S MANUAL SLC TWIN PRO2 UNINTERRUPTIBLE POWER SUPPLY (UPS)
This manual describes the installation and operating of the Uninter- the batteries: ruptible Power Supply [UPS] from SLC TWIN PRO2 series as equip- ments that can run as a complete separate and independent units. B0 Equipment without batteries and with the necessary acces- UPSs from SLC TWIN PRO2 series assures an optimal protection for sories to install the batteries.
• Control signal of the remote emergency power off [EPO]. The available SNMP option for SLC TWIN PRO2 series is a card to be • Interface between the user and the equipment through the con- inserted into the slot that the UPS has in its rear side.
UPS input line, output or in both, pro- tections against indirect contact has to be fitted in (residual cur- rent device) at the output of each transformer, because due to its specification of isolation it will prevent the triggering of the SALICRU...
If the distance is high, it is recommended to move the equipment the equipment. still packaged till the installation place and unpack it later. When discrepancies exist between the labelling and the instruc- tions of this manual, the labelling will always prevail. USER'S MANUAL SLC TWIN PRO2 UNINTERRUPTIBLE POWER SUPPLY (UPS)
Each battery module is independent for each equipment. • with a two pole circuit breaker protection sized to the features It is strictly prohibited to connect two equipments to one battery module. stated in table 2. SALICRU...
Choose the operating platform that you need and follow the instructions described in the web site to download the soft- ware. When downloading the needed files from Internet, enter the following licence to install the software: 511C1-01220-0100-478DF2A . USER'S MANUAL SLC TWIN PRO2 UNINTERRUPTIBLE POWER SUPPLY (UPS)
On bypass mode «bYPA», the UPS will still be supplying output key «ON» (see table 3). voltage through its bypass, so to shutdown the loads com- pletely, the circuit breaker switch from control panel will have to be turned off too. USER'S MANUAL SLC TWIN PRO2 UNINTERRUPTIBLE POWER SUPPLY (UPS)
A LCD panel. Display Function Input information It displays the input voltage/frequency figure alternately. It shows the input is connected to mains (input power is single phase). Output information It displays the output voltage/frequency figure alternately. (*1) SALICRU...
On this operating mode, the UPS doesn’t have back up time function, Overload OVLD so in case of mains failure, the loads will be shutdown. Extra-charger failure dCHF Internal temperature high ITPH Tab. 5. Code list and their meaning. USER'S MANUAL SLC TWIN PRO2 UNINTERRUPTIBLE POWER SUPPLY (UPS)
220 – 230 – 240 – 220 – 230 . Press the “Enter” are short-circuited, so the UPS inverter is faulty. See table 6 of sec- button to confirm the selected output voltage and the UPS will tion 8. change its output voltage. SALICRU...
Page 23
“UPS” is blinking after pressing the “Enter” button. to frequency converter mode through the LCD panel. MOdE Step 5: “ECO” is blinking after pressing the “Select” button. Step 1: “OPV” is displayed after pressing the “Enter” button. USER'S MANUAL SLC TWIN PRO2 UNINTERRUPTIBLE POWER SUPPLY (UPS)
Page 24
Step 6: “CVF” is blinking after pressing the “Select” button. Finally press the “Enter” button to confirm. To escape from setting mode press the “Enter” button shortly. Fig. 21. Step 1 to 6: Example for setting the equipment param- eters SALICRU...
Check the environment ventilation. INVH Inverter voltage is too high. UPS internal fault. Call the Technical Service and Support. INVL Inverter voltage is too low. UPS internal fault. Call the Technical Service and Support. USER'S MANUAL SLC TWIN PRO2 UNINTERRUPTIBLE POWER SUPPLY (UPS)
Neither it will cover, in any case, compensations for damages or injuries. 8.4. TECHNICAL SERVICE NETWORK. Coverage, both national and international, from our Technical Ser- vice & Support (T.S.S.), can be found in our Website. SALICRU...
Page 27
> 180 %, 300 ms. Batteries Voltage / capacity 12 V DC / 9 Ah Quantity of batteries in serial / set voltage 2 / 24 V DC 4/ 48 V DC 6/72 V DC USER'S MANUAL SLC TWIN PRO2 UNINTERRUPTIBLE POWER SUPPLY (UPS)
Page 28
FET gate for the input and a bipolar numerical operations are needed with very fast speed. Due to this, it transistor as switch in a single device. The triggering circuit of the IGBT SALICRU...
Page 29
As they are harmonics, it means multiple of the input signal, this distortion is not so dissonant and it is more difficult to detect. USER'S MANUAL SLC TWIN PRO2 UNINTERRUPTIBLE POWER SUPPLY (UPS)
Page 32
Avda. de la Serra 100 08460 Palautordera BARCELONA Tel. +34 93 848 24 00 Fax +34 93 848 22 05 services@salicru.com SALICRU.COM The Technical Service & Support (T.S.S.) network, Commercial network and warranty information are available in website: www.salicru.com Product Range...