Installation; Tools Needed; Unpacking - Landice 90 Series Owner's Manual

2. Installation

2.1.

Tools Needed

• Socket set with 3/8" socket, 1/2" socket, and 9/16" socket
• Open end wrenches 14mm and 19mm, or adjustable
open end wrench
• Hex wrenches: 4mm, 5mm, 6mm
• Cross-tip screwdriver
• Razor blade knife
2.2.

Unpacking

Unpacking and installation of the treadmill should be done by a
qualified technician. The packaged treadmills are very heavy
and weigh as follows:
• L7 models: 360 lb, packaged
• L8 models: 435 lb, packaged
WARNING
Move the shipping crate/pallet to location of final
Note:
assembly. Allow 3-5 feet working space to safely remove
box and pallet.
For L7 treadmills begin with step 1, for L8 treadmills step
Note:
2.
1. Carefully lower L7 treadmill crate from the upright position
(Figure 2-1) to horizontal position (Figure 2-2). While
lowering, place upper end of crate/pallet onto a sturdy item
such as a tool box. With crate/pallet securely placed on tool
box, remove the top two shipping bolts with 1/2" socket as
shown in Figure 2-1. Carefully lift, remove tool box and
lower pallet onto floor. Repeat this step at the opposite end
of pallet to remove bottom two shipping bolts.
To avoid injury, use caution when moving
and lifting the treadmill during unpacking
and assembly.
21