AMX UDM-0102 Operation/Reference Manual page 34

1x2 multi-format distribution hub; multi-format receiver

Hide thumbs Also See for UDM-0102:

Table of Contents

Configuration

FIG. 14

UDM-0102 WebConsole - Initial View (Status page)

After setup you can change TCP/IP address and connect the UDM-0102 to your network equipment (switch,

Hub, or serial port).

Use the links in the left-pane of the page to access each of the main Configuration pages, as described in the

following sections.

For the initial setup, you will probably need to visit the Setup page first, to establish network settings for the

UDM-0102 (see the Configuration - Setup Page section on page 33).

Click links to access the main

areas of the WebConsole

(initial view is the Status page)

UDM-0102 and UDM-RX02 Operation/Reference Guide

Table of Contents

Udm-rx02