Editing Parameters In Level 2; Setting The Blade Position - DURKOPP ADLER 512-211-01 Service Instructions Manual

Programming
3. Press the Ready button to confirm the parameter.
 The LED in the button illuminates.
4. Press the +/- Function buttons to change values.
5. Press the Reset button to reset a changed value.
6. Press the Ready button to save a change.
 The LED in the button switches off.
7. Press the Memory button.
 The LED in the button switches off.

11.2.2 Editing parameters in level 2

Prerequisite:
• The machine is in the programming mode, the LED in the Ready button
1. Press and hold the Memory button for 6 seconds.
 The controller beeps 2x; the LED in the button illuminates.
2. Press the +/- Program buttons to select other parameters.
3. Press the Ready button to confirm the parameter.
 The LED in the button illuminates.
4. Press the +/- Function buttons to change values.
5. Press the Reset button to reset a changed value.
6. Press the Ready button to save a change.
 The LED in the button switches off.
7. Press the Memory button.
 The LED in the button switches off.

11.3 Setting the blade position

Prerequisite:
• The machine is in the programming mode, the LED in the Ready button
1. Press and hold the Memory button for 6 seconds.
 The controller beeps 2x; the LED in the button illuminates.
2. Press the +/- Program buttons and select parameter U099.
Service Instructions 512-211-01/532-211-01 - 01.0 - 10/2017
is off.
The Program display shows the parameter numbers; the Function
display shows the values.
is off.
The Program display shows the parameter numbers; the Function
display shows the values.
37