Adjusting the thread wiper
8
Fig. 23: Adjusting the thread wiper
(1) - Screw
Adjusting steps
1. Loosen the screw (1).
2. Adjust the thread wiper. When doing this observe the minimum distance
3. Tighten the screw (1).
Service Instructions 512-211-01/532-211-01 - 01.0 - 10/2017
Adjusting the thread wiper
WARNING
Risk of injury from sharp and moving parts!
Crushing hazard and puncturing injuries due to
moving and sharp parts.
Switch off the sewing machine before adjusting the
thread wiper.
1.5 mm
of 1.5 mm to the needle and the distance range of 23 to 25 mm when
pivoting. When using a thin needle set the distance at 23 mm.
①
23-25 mm
31