Table of Contents
Advertisement
Error
Meaning
E
3
0 5 Error thread trimmer
position
E
3
0 6 Error thread catcher
position
E
3
3 2 Error clamp foot
position
E
5
0 1 Data read error
E
5
0 2 USB read error
E
5
0 3 SUM read error
E
5
0 4 End block error
E
5
0 5 USB read error
E
5
0 6 USB read error
E
5
0 7 Read error own
sewing patterns
E
5
0 8 File error own
sewing patterns
E
5
0 9 File error own
sewing patterns
E
5
1 0 File error own
sewing patterns
E
5
1 1 USB write error
E
5
1 2 USB read error
E
5
1 3 USB write error
E
5
5 0 Data write error
E
5
5 1 Internal process
error
E
7
0
7
Motor signal error
7
3
5
E
7
3 6 Motor rotation error Motor stops / encoder has
56
Possible cause
Thread trimmer blade not
at home position
Thread catcher not at home
position
Clamp foot not at home
position
Data not available or in the
wrong format
MOT file error
CHECKSUM data error in
MOT file
No end block in the MOT
file
USB stick not found
Unable to read U01 ~ U10. • Set main switch to OFF.
U01 ~ U10 read error
U01 ~ U10 read error
U01 ~ U10 read error
U01 ~ U10 read error
File with the same name
already exists
Data cannot be loaded
from USB stick
Data cannot be copied to
USB stick.
Flash memory transfer
error
Softwar error
Encoder / motor has no sig-
nal
no signal
Service Instructions 512-211-01/532-211-01 - 01.0 - 10/2017
Troubleshooting
Remedial measures
Process in the order specified!
• Set main switch to OFF.
• Check sensor.
• Set main switch to OFF.
• Check sensor.
• Set main switch to OFF.
• Check sensor.
• Save the data to a USB stick again.
• Save the data to a USB stick again.
• Save the CHECKSUM file to a USB stick
again.
• Save the end block file to a USB stick
again.
• Set main switch to OFF.
• Set main switch to ON.
• Reinsert USB stick.
• Set main switch to ON.
• Reinsert USB stick.
• Download the data again.
• Check file type.
• Check file type.
• Check file type.
• Save data to USB again.
• Delete or rename file.
• Check USB stick.
• Reinsert USB stick.
• Check USB stick.
• Reinsert USB stick.
• Set main switch to OFF.
• Repeat process.
• Replace the mainboard.
• Set main switch to OFF.
• Repeat process.
• Replace the mainboard.
• Update software.
• Check motor / encoder.
• Check motor / encoder.
Advertisement
Table of Contents
