Adjusting The Thread Trimmer - DURKOPP ADLER 512-211-01 Service Instructions Manual

6
For the thread trimmer to work correctly, you must set the thread puller
blade and the counter blade.
Faults caused by an incorrect setting
• Threads are not cut
• Threads are cut too long
Cover
• Remove the throat plate ( S. 17).
Fig. 20: Adjusting the blades
(1) - Needle guide
(2) - Thread trimmer lever
(3) - Screw for thread trimmer lever
Adjusting steps
1. Loosen the screw (3).
2. Set a distance of 18.5 mm between the front of the throat plate and
3. Tighten the screw (3).
4. Loosen the counter blade screws (4).
5. Move the counter blade and set a distance of 0.5 mm between the
6. Tighten the counter blade screws (4).
28

Adjusting the thread trimmer

WARNING
Risk of injury from sharp and moving parts!
Crushing hazard and puncturing injuries due to
moving and sharp parts.
Switch off the sewing machine before adjusting the
blades.
①
the thread trimmer lever (5).
needle guide (1) and the counter blade (5).
Adjusting the thread trimmer
(4) - Counter blade screw
(5) - Counter blade
Service Instructions 512-211-01/532-211-01 - 01.0 - 10/2017
⑤
④
③
②