3. Press the Ready button to confirm the parameter.
The LED in the button illuminates. The Program display shows
4. Press button P1.
The thread trimmer sensor disk travels to position.
Fig. 28: Setting the blade position
5. Check to see if the hole of the thread puller blade and the needle guide
Fig. 29: Checking the hole of the thread puller blade
6. Press button P1.
The thread trimmer sensor disk travels to position again.
38
"°°20".
of the throat plate are aligned:
• Case A: The setting is wrong; the thread puller blade overlaps the
counter blade:
Adjust blade sensor upwards.
• Case B: The setting is wrong; the thread puller blade overlaps the
needle guide:
Adjust blade sensor downwards.
• Case C: The setting is correct.
A
C
B
Service Instructions 512-211-01/532-211-01 - 01.0 - 10/2017
Programming