Select Communications Writing - Omron E5CN-H Communications Manual

■ Select Communications Writing

● Alarm
• Even when alarms 1 and 2 are not displayed on the Controller's
display, they function normally in communications.
• Only alarms 1 and 2 are supported.
• Alarm 3 cannot be used.
● Heater Burnout Detection
Reads the Heater Burnout Detection 1 parameter. (The Heater Burnout
Detection 2 parameter value is not read.)
The logic of the MB command changes as shown in the table below
according to the MB command logic switching setting (advanced
function setting level). The MB command (communications writing
selection) is equivalent to the E5@J Controller's MB command (remote/
local switching).
Text data of MB
command
Communications writing
0000 enabled (remote mode
selection)
Communications writing
0001 disabled (local mode
selection)
• The default value of the MB Command Logic Switching Setting is OFF
(same logic as E5@J).
4.2 Command Descriptions
MB command logic switching setting
OFF
Communications writing
disabled (local mode
selection)
Communications writing
enabled (remote mode
selection)
ON
4-9