Configuration Settings; Notch Filter; Allow Card Erase; Display Elapsed Time - ZOLL M Series CCT Configuration Manual

Configuration Settings

Configuration Settings
The name of each configurable feature is displayed in the left column of the option menu and
that feature's current setting is shown in the right column.
Pressing the Change Value softkey allows you to sequence through the available settings for
the highlighted feature. When the desired setting is displayed, pressing the Next Item softkey
will enter the selection and move the highlight to the next feature. Pressing the Prev Item
softkey will enter the selected setting and move the highlight to the previously selected feature.
Pressing the Main Menu softkey will cause the unit to return to the Main Configuration menu.
Pressing the Exit Config softkey will cause the unit to display the "Save Changes and Exit"
screen.
NEXT MENU is displayed on the screen when other option menus are available. Press the Next
Item softkey until the new menu is displayed.
PREV MENU is displayed on the screen when other previously displayed option menus are
available. Press the Prev Item softkey until the previous menu is displayed.

Notch Filter

Sets the ECG Notch Filter frequency for proper AC mains interference rejection.

Allow Card Erase

Allows the user to erase PCMCIA data cards on the M Series CCT unit when set to "Yes".

Display Elapsed Time

Allows the user to display the elapsed time since the unit was turned on, when enabled. The
elapsed time will continue to be counted for up to 10 seconds after power down. This will give
the operator adequate time to change the battery without resetting the elapsed timer.
Elapsed time will be reset to zero (0:00) whenever the unit has been off for more than 10
seconds.

Voice Markers Enabled

When voice markers are enabled, the unit will record five seconds of audio data in internal
memory immediately following each depression of the CODE MARKER button. This audio
recording along with a time stamp can be played back when the SUMMARY button is pressed.
Note: This option is not yet implemented.
7