Storage; 8Qsdfnlqj Dqg Wudqvsruw - Alpha-InnoTec SWC V series Operating Manual

5.2 Storage

:KHUH SRVVLEOH GR QRW XQSDFN WKH XQLW XQWLO
directly before installation.
Store unit protected against:
– Moisture/damp
– Frost
– Dust and dirt

5.3 8QSDFNLQJ DQG WUDQVSRUW

Notes on safe transport
The housing with the unit components and the
module box are heavy (Æ "Technical data/Scope of
VXSSO\´ RQ SDJH   7KHUH LV D ULVN RI LQMXULHV
or damage to property if the housing with the unit
components falls or overturns or if the module box
falls.
The housing with the unit components and
module box must be transported and installed
by several persons.
Secure the housing with the unit components
during transport. Carry the module box by the
carrying lugs.
7KHUH LV D ULVN RI FXWWLQJ \RXU KDQGV RQ VKDUS HGJHV
of the unit.
Wear cut resistant protective gloves.
The hydraulic connections are not designed for
mechanical loads.
Do not lift or transport the unit by the hydraulic
connections.
If the module box is tilted by more than 45°,
compressor oil runs into the cooling circuit.
Do not tilt the unit with installed module box by
more than 45°.
7UDQVSRUW WKH XQLW SUHIHUDEO\ ZLWK D SDOOHW WUXFN
alternatively with a handcart.
7UDQVSRUW ZLWK D SDOOHW WUXFN
Transport the unit to the place of installation
SDFNDJHG DQG VHFXUHG RQ D ZRRGHQ SDOOHW
10
Subject to change without notice | 83057000cUK – Translation into English of the original German operating manual | ait-deutschland GmbH
8QSDFNLQJ
NOTE
,I WKH XQLW LV QRW WUDQVSRUWHG E\ D SDOOHW WUXFN
'R QRW OLIW RII WKH SDOOHW XQWLO DIWHU XQSDFNLQJ
and dismantling the housing panels.
1. 5HPRYH SODVWLF ¿OPV (QVXUH WKDW \RX GR QRW
damage the unit.
2. 'LVSRVH RI WKH PRXQWLQJ EUDFNHW WUDQVSRUW
DQG SDFNDJLQJ PDWHULDO LQ DQ HQYLURQPHQWDOO\
friendly way according to local regulations.
3. 5HPRYH WKH ¿OP IURP WKH SODVWLF HOHPHQW RI WKH
front panel in the place of installation.
Dismantle housing panels for transport with
handcart or carrying the unit
9
8QLW LV XQSDFNHG Æ ³8QSDFNLQJ´ RQ SDJH  
1. To avoid damage to the housing panels:
– Undo 2 screws at the bottom of the front
panel.
– Lift up the front panel and put down in safe
place.
– Undo 3 screws in each side panel.
– Lift up side panels and put down in safe
place.
2.
1.
8x
3.