Introduction; General Description; Mx19 Work Platform - Upright MX19 Service And Parts Manual

I
NTRODUCTION
1.1 I
NTRODUCTION
1.2 G D
ENERAL
DO NOT use the work platform without guardrails properly assembled and in
place.
Page 1-1
P
URPOSE
The purpose of this service and parts manual is to provide instructions and illustrations for
the operation and maintenance of the MX19 manufactured by UpRight Powered Access.
S
COPE
The manual includes procedures for proper operation, maintenance, adjustment, and repair
of the MX19 as well as recommended maintenance schedules and troubleshooting.
ESCRIPTION
The MX19 consists of the platform, controller, elevating assembly, power module, control
module, and chassis.
W A R N I N G
!
P
LATFORM
The platform has a reinforced steel floor,
1.11 m (43.75 inch) high guardrails with
midrail, 6 inch (152 mm) toeboards, and
an entrance gate at the rear of the
platform.
P C
LATFORM ONTROLLER
The platform controller contains the
controls to operate the machine. It is
located at the front of the platform. A
complete explanation of control functions
can be found in Section 2.
E A
LEVATING SSEMBLY
The platform is raised and lowered by
the elevating assembly. The hydraulic
pump, driven by an electric motor,
powers the cylinder. Solenoid operated
valves control raising and lowering.
!
Figure 1-1: MX19 Work Platform
1
3
4
5
1.Platform
2.Platform Controller
3.Elevating Assembly
4.Chassis Controls
5.Chassis
Section 1
2