5.2.4 Rectifier/Interrupter
The Rectifier/Interrupter control/status group affect operation of the rectifier interrupter relay. The rectifier output may
be turned on or off by pressing the "Rectifier Off" or "Rectifier On" buttons, respectively. The rectifier output may be
cycled off and on by pressing the "Cycle Interrupter" button and entering the pertinent cycle parameters. Finally, the
rectifier output status may be polled by clicking the "Rectifier Status" button.
5.2.5 Radio Communications
The Radio Communications group is used to determine the status of a communications channel that uses wireless
communications. Pressing the "Status" button returns a dialog with signal strength information and status information
that is dependent on the wireless communication channel in use at the time.
For communications systems that allow a test transmission, press the "Send Test Transmission" to initiate the sending
of a test message.
5.2.6 Retrieve Logs
The two buttons in this group are used for retrieving event and data logs from the RMU5. If the "Delete files after read"
is checked, the RMU5 will be cleared after the files are retrieved. Clicking either button brings up a file dialog to locate
where the files will be placed after retrieval from the RMU5.
MOBILTEX® DATA LTD.
Calgary, Alberta
TITLE:
RMU5 Generic Installation and Configuration Guide
DOCUMENT NO.:
SHEET:
RMU5-MAN-001
REV:
46 of 69
1.10