Rmu Configuration; Figure 32 Configuration Application Main Screen Connected - Cortalk RMU5 Generic Installation And Configuration Manual

Important Note: The minor and major version numbers of the RMU5Setup application must match the version
of the connected RMU5 firmware. If it does not match, RMU5Setup will present a warning box indicating that
the RMU5 firmware or the configuration application must be updated. If the RMU firmware version is higher
than the configuration application version, then the configuration application must be updated to match. If the
RMU firmware version is lower than the configuration application version, then the "Update Firmware" function
may be used to update the RMU firmware to a compatible level.
The most current manual, firmware, and configuration applications can also be downloaded from the following URL:
http://www.mobiltex.com/cathodic/rmu5generic
Once connected, the status information below the "Connect" button will indicate that the RMU is connected, and the
version number of the software on the RMU5. The "Connect" button label will also change to "Disconnect", as shown
in the following screen shot:

Figure 32 Configuration Application Main Screen Connected

RMUSetup is now connected to the RMU5 and the RMU5 can now be configured.

5.2.1 RMU Configuration

Configuration editing is always performed on a local copy of the configuration file. If the RMU5 has never been
configured, click the "Install Defaults" button for a default configuration. If the RMU5 has already been configured and
some changes are required to the configuration, read the configuration back from the RMU5 using the "Read From
RMU" button.
MOBILTEX® DATA LTD.
Calgary, Alberta
TITLE:
RMU5 Generic Installation and Configuration Guide
DOCUMENT NO.: SHEET:
RMU5-MAN-001
REV:
30 of 69 1.10