Operation; Meaning Of Display And Buttons - Siemens RWF 50.2 Installation, Use And Maintenance Instructions

Initialization
Basic display
Parameter display
Self-setting function
Flashing actual value
display
Manual control
32/68
20089337
6

Operation

6.1 Meaning of display and buttons

Controlling
element CLOSE
Controlling
element OPEN
ESC button
Decrease value
Figure 16: Meaning of display and buttons
The two 7-segment displays (red and green) show hyphens and all LEDs light up for
about 5 seconds.
The upper display (red) shows the actual value.
The lower display (green) shows the setpoint.

Reference!
See chapter 8.6 Display diSP.
When entering parameters, the parameter symbol at the bottom (green) and the set
value at the top (red) appear.
The actual value is shown on the actual value display (red) and tUnE flashes on the
setpoint display (green).

Reference!
See chapter 9 Self-setting function.
The actual value display (red) shows 9999 flashing.

Reference!
See chapter 11 What to do if ...
The setpoint display (green) shows HAnd flashing.

Reference!
See chapter 6.4 Manual control of a modulating burner.
Burner release
Operating mode 2-stage
ESC
RWF50.x
Actual value display (red)
and parameter value
USB-LED
Setpoint display (green)
and parameter symbol
Enter button
Enter
Increase value
7866z03e/0212