Display Disp - Siemens RWF 50.2 Installation, Use And Maintenance Instructions

Parameter
Upper display
diSU
Upper display
Lower display
diSL
Lower display
Timeout
tout
Decimal point
dECP
Decimal point
Locking of levels
CodE

8.6 Display diSP

By configuring the position of the decimal point and automatic changeover (timer), both
LED indications can be adapted to the respective requirements. Timeout
operation and the locking of levels can be configured as well.
ConF  dISP 
Value/ Description
selection
Display value for upper display
0 Switched off
Analog input InP1
1
4 Controller's angular positioning
6 Setpoint
7 End value with thermal shock protection
Display value for lower display
0 Switched off
Analog input InP1
1
4 Controller's angular positioning
6 Setpoint
7 End value with thermal shock protection
0... Time (s) on completion of which the controller returns automatically to the
basic display, if no button is pressed
180...
255
0 No decimal place
1 One decimal place
2 Two decimal places
If the value to be displayed cannot be shown with the programmed decimal
point, the number of decimal places is automatically reduced. If the
measured value drops again, the number of decimal places is increased
until the programmed value is reached
0 No locking
1 Locking of configuration level
2 Locking of parameter level
3 Locking of keyboard
tout
for
47/68
20089337