Installing The Handle - Felix printers Tec 4 Quick Start Manual

Chapter 1: Unboxing

1.3 Installing the Handle

2
1. Put the T-nut upright into the T-slot of the profile.
2. Twist the T-nut 90 degrees in place.
3. Repeat this for both T-nuts.
FELIXprinters Quick Start Guide for the FELIX Tec 4
1
2
1
1. Fix the handle against the vertical profile with the
two hexagon screws. Use a hex key size 5.
2. Press the handle cover on the handle
1
Page 9