Planet GSW-2416SF User Manual page 37

Object Description
Port
Indicate port 1 to port 24.
Mode
Allow configuring the port speed and operation mode. Draw the menu bar to select the mode.
Flow Control
Allow Enable or Disable flow control for selected port.
Enable – 802.3x flow control is enabled on Full-Duplex mode or Backpressure is enabled on
Disable – No flow control or backpressure function on no matter Full-Duplex or Half-Duplex mode
VLAN aware
Allow Enable or Disable VLAN aware for selected port.
* Additional function
VLAN tag
Allow Enable or Disable VLAN Tag for selected port.
* Additional function
When adding a VLAN to selected port, it tells the switch whether to keep or remove the tag from a
frame on egress.
VLAN priority
Allow assign 802.1p priority for selected port.
The range for the priority is 0-7 (0~3 for low priority; 4~7 for high priority )
PVID
Allow assign PVID for selected port.
The range for the PVID is 1-4095 ; 0 reserved for management purpose
* Additional function
The PV
as the VLAN ID that the port belong to VLAN group, or the untagged traffic will be dropped.
Click "Apply" button to affect the configured function.
Notice:
Change VLAN settings for every time, you have to reboot the switch to apply new settings.
VLA N Tag:
Tagged-based VLAN is an IEEE 802.1Q specification standard. Therefore, it is possible to create a VLAN across devices
from different switch venders. IEEE 802.1Q VLAN uses a technique to insert a "tag" into the Ethernet frames. Tag contains
a VLAN Identifier (VID) that indicates the VLAN numbers.
To set the outgoing frames are VLAN-Tagged frames or untagged.
Tag: outgoing frames with VLAN-Tagged.
UnTag: outgoing frames without VLAN-Tagged.
PVID:
Set the PVID that will be assigned to untagged traffic on a given port. This feature is useful for accommodating devices that
you want to participate in the VLAN but that don't support tagging. The switch each port allows user to set one PVID, the
range is 0~4095, default VLAN ID is 0. The PVID must as same as the VLAN ID that the port belong to VLAN group( See
chapter 5.3 – VLAN Setup), or the untagged traffic will be dropped.
EM-GSW2416SFv1
Auto Speed - Setup Auto negotiation.
10 half - Force sets 10Mbps/Half-Duplex mode.
10 Full - Force sets 10Mbps/Full-Duplex mode.
100 half - Force sets 100Mbps/Half-Duplex mode.
100 full - Force sets 100Mbps/Full-Duplex mode.
1000 full - Force sets 10000Mbps/Full-Duplex mode.
Disable - Shutdown the port manually.
Half-Duplex mode.
Frame remain original VID while leaving tagged port.
Enable – Tagged
Frame wouldn't remain original VID while leaving tagged port.
Disable - Tagged
Enable - Outgoing frames with VLAN-Tagged.
Disable - Outgoing frames without VLAN-Tagged.
ID will be inserted into all untagged frames entering the ingress po
Table 5-1 Descriptions of the Port Configuration screen Objects
rt. The PVID must as same
- 37 -